Note

Ensure that flanged sleeve bushing stays aligned with mark on rear feed plate during the next step.

b. Install flanged sleeve bushing (1) into the rear plate assembly (2) until the flange of the bushing is flush with the rear plate assembly (2).

c. Lubricate and install new preformed packing (3) in lower feed shaft flanged sleeve bushing (1).

2. INSTALL CARTRIDGE STOPS.

a. Using acid brush, apply a light coat of grease to two new preformed packings (4) and install new preformed packings into slots in cartridge stops (5).

b. Using acid brush, apply a generous coat of grease to cartridge stops (5) and insert cartridge stops (5), with pointed end out, into holes (6).

Feed Shaft Stops M242

1df0835

1df0836

3. INSTALL REAR GATE ASSEMBLY.

a. Place rear plate assembly (2) on its edge as shown.

b. Install helical spring (7) into rear plate assembly (2).

c. Place rear gate assembly (8) over helical spring on rear plate assembly (2).

Was this article helpful?

0 0

Post a comment