Note

Damper nut threads, recoil mechanism threads, bearing surface of damper nut, and damper nut bearing surface on breech lug must be free of lubricant.

a. Pull recoil mechanism (3) out of barrel support assembly (5) 1 in. (25.4 mm). Place damper nut (6) over end of damper housing assembly (4). Push recoil mechanism (3) into barrel support assembly (5) again until it stops.

b. Install damper nut (6) halfway on threads of damper housing assembly (4).

Free M16 Blueprints

3. INSTALL HOUSING RECOIL CAP.

Was this article helpful?

0 0

Post a comment