Note

If you are installing an electrical feed select solenoid with an integral wiring harness (PN 12524181), proceed to step 2.

1. ASSEMBLE ELECTRICAL FEED SELECT SOLENOID BODY AND WIRING HARNESS.

a. Install harness connector (1) into electrical feed select solenoid body (2) with two captive screws (3).

b. Lockwire two captive screws (3).

M242 25mm Bevfitchett

2. INSTALL ELECTRICAL FEED SELECT SOLENOID.

a. Push red select knob (4) in until it stops.

b. Place plunger tip (5) into fork actuator T-slot (6) in automatic gun feeder (7) and align holes.

c. Install and torque six capscrews (8) to 80 in.-lb ± 5.0 in.-lb (9.04 N-m ± 0.57 N-m).

Bevfitchett M242 25mm

Was this article helpful?

0 0

Post a comment