Note

The sear release link might have to be depressed slightly, from the bottom of the auto gun receiver, in order to slide the rear chain guide flush against the rear wall of the auto gun receiver.

g. With rear chain guide (21) resting on floor of auto gun receiver (2), slide it flush against rear wall (27) of auto gun receiver (2).

ASSEMBLY - Continued h. Turn auto gun receiver (2) on side so mechanical interlock will not fall out. Finger tighten two capscrews.

i. Turn auto gun receiver (2) over so that mechanical housing (14) is on top. j. Torque two capscrews (28) to 80 in.- lb ± 5 in.-lb (9.04 N-m ± 0.57 N-m).

Was this article helpful?

0 0

Post a comment