Note

Do not remove headed straight pin from center of round positioner assembly. a. Remove cotter pin (3) from upper headed straight pin (4). Discard cotter pin.

3. POSITION FEEDER DRIVE ASSEMBLY.

Place feeder drive assembly (1) with lower feed sprocket assembly (2) on bottom.

4. REMOVE CAPS CREW.

Remove capscrew (7) from upper left stepped spacer (8).

REMOVAL - Continued

5. REMOVE ROUND POSITIONER ASSEMBLY.

a. Spread round positioner assembly (6) and pull it with upper left stepped spacer (8) from around sprocket shafts (9).

1df0312

b. Remove self-locking nut (10), two flat washers (11), and capscrew (12). Discard self-locking nut.

c. Slide upper left stepped spacer (8) out of round positioner assembly (6).

INSPECTION

INSPECT ROUND POSITIONER ASSEMBLY.

Visually inspect flat spring (1) and round positioner (2) for cracks, broken parts, distortion, and corrosion. If any of these conditions exist, repair round positioner assembly (WP 0038 00).

LUBRICATION

Was this article helpful?

0 0

Post a comment