Note

Steps a and b are to be done at the same time.

There are two sets of timing marks on larger gear on the gear clutch assembly and one set on the small gear.

It may be necessary to rotate the worm shaft nut to allow for alignment of timing marks.

a. Place gear clutch assembly (30) into feeder housing assembly (2), with long shaft on top and the timing marks on the small gear (31) pointing towards the upper feed shaft (32).

M242 25mm Timing Marks

ASSEMBLY - Continued b. Time gear clutch assembly (30) by aligning three timing marks (33).

M242 Worm Gear

Was this article helpful?

0 0

Post a comment