Note

Do not apply grease to outside surface of rear plate assembly.

a. Apply a light coat of grease to bearings in rear plate (8), spur gears (9), fork shaft assembly (10), yoke actuator (11), worm wheel gear (12), gear clutch assembly (13), and clutch yoke assembly (14).

b. Apply a generous coat of grease to cartridge stops (15) on rear plate (8).

M242 25mm Spur Gears

LUBRICATION - Continued

3. LUBRICATE INDEX DRIVE SHAFT ASSEMBLY.

Apply a light coat of grease to cam set (16), rotor stub (17), and index drive shaft (18).

4. LUBRICATE PAWL-SHAFT ASSEMBLY, TIMER LEVER, AND ACCESS COVER.

Apply a light coat of grease to pawl-shaft assembly (19), timer lever (20), and access cover spring (21).

M242 Feeder

5. LUBRICATE BEVEL GEAR AND HUB.

Apply a light coat of grease to entire bevel gear (22) and bushing (23) of hub (24).

6. LUBRICATE FEEDER DRIVE HOUSING BUSHINGS AND BEARINGS.

Apply a light coat of grease to bushings (25) and bearings (26) on feeder drive housing (27).

Bevfitchett M242 25mm

ASSEMBLY

1. INSTALL TIMER LEVER AND PAWL-SHAFT ASSEMBLY.

a. Place timer lever (1) into recess of feeder housing assembly (2).

b. Push long end of pawl-shaft assembly (3) into rear of feeder housing assembly (2) and through timer lever (1).

Bevfitchett M242 25mm

ASSEMBLY - Continued

2. INSTALL ACCESS COVER.

a. Place access cover (4) on feeder housing assembly (2).

Was this article helpful?

0 0

Post a comment