If weapon has been determined to be contaminated (radioactive), all warnings at the beginning of WP 0022 00 shall be in effect.
Do not wear jewelry when working on the gun. Serious injury or death may occur. Keep fingers away from moving parts of gun. Serious injury or death may occur.
WP 0027 00 Link bridges removed (Standard feeder only) WP 0028 00 Link cover assemblies removed
(Enhanced feeder only) WP 0029 00 Link shield removed WP 0031 00 Rear link strippers removed WP 0032 00 Ejection chute removed WP 0034 00 Forward feed assembly removed WP 0036 00 Feeder assembly rotor removed WP 0039 00 Upper and lower feed sprocket assemblies removed WP 0040 00 Feeder standoff removed WP 0041 00 Stepped spacers removed WP 0042 00 Upper eject guide removed WP 0043 00 Feed shaft stops removed WP 0045 00 Electrical feed select solenoid removed (Standard gun only) WP 0046 00 Electrical feed select solenoid body removed
WP 0047 00 Feed select solenoid wiring harness removed
Special Environmental Conditions
Well-ventilated area required when using dry cleaning solvent.
1. POSITION FEEDER HOUSING ASSEMBLY.
Place feeder housing assembly (1) on its side as shown.
2. REMOVE CAPSCREWS.
Remove two capscrews (2) from rear plate assembly (3).
3. POSITION FEEDER HOUSING ASSEMBLY.
Stand feeder housing assembly (1) on end with feeder handle (4) on top.
4. REMOVE CAPSCREWS.
a. Remove two capscrews (5) from feeder housing assembly (1).
b. Turn feeder housing assembly (1) so feeder handle (4) is towards you.
c. Remove four capscrews (6) from rear plate assembly (3).
Was this article helpful?