Warning

Wear eye protection when cutting lockwire. You can be blinded if wire hits you in the eye.

Do not drop lockwire pieces into gun. Wire can get between moving parts and damage gun.

If upper portion of connector is green, only remove lockwire from lower connector. If upper portion of connector is blank, only one section of connector is lockwired. DO NOT tear lockwire from connector. Damage to connector may result.

2. REMOVE LOCKWIRE FROM ELECTRICAL CONNECTOR.

Remove lockwire between electrical sear solenoid connector (3) and connector lock ring (4).

3. DISCONNECT ELECTRICAL CONNECTOR.

a. Turn connector lock ring (4) counterclockwise until free.

b. Pull electrical sear solenoid connector (3) straight out until disconnected from motor/sear plug.

Was this article helpful?

0 0

Post a comment