Note

The right and left rails (23) are interchangeable.

The end of each rail with the partial groove (larger numbers) should be toward the muzzle of the weapon.

Install new lock washer (22) on each of six screws (21). Insert screw (21) through the forward mounting hole of rail (23) so the head of screw (21) sits in the counter bore in the rail (23). Align an insulator (25) between the rail (23) and rail body (24), insert screw into the rail body (24) and tighten screws finger tight. Repeat for rear screws.

Align an insulator (25) between the rail (23) and rail body (24). Insert center screws (21) through rail body (24) from the inside, push screw (21) through the insulator (25) into the rail (23) and tighten screws finger tight.

Was this article helpful?

0 0

Post a comment