Note

The ball end of the firing pin must be positioned in groove between the spring pin hole and the bottom of the groove in the operating rod assembly.

Install ball end (6) of the firing pin (5) into the groove (7) in operating rod assembly (3).

Install spring pin (4) so that the ball end (6) of firing pin (5) is properly seated in groove (7) of operating rod assembly (3).

11826059 Tool Combination
1BL0069

Install bolt assembly (2) on operating rod assembly (3) and secure with spring pin (1).

Make sure bolt linkage moves freely by moving bolt assembly (2) through range of operation. If movement is not free, check spring pin (1) and mating surfaces for damages.

11826059 Tool Combination

This task covers: a. Disassembly b. Cleaning

INITIAL SETUP

Tools and Special Tools

Combination tool, PN 11826059 Ejector removing tool, PN 11826067 Tool Kit, Small Arms Repairman, PN SC 5180-95-B71; SL-3-08724A (Marine Corps only); SL-3-00607A (Marine Corps only)

Materials/Parts

Cleaner, lubricant and preservative (CLP) (item 1, WP 0074 00)

c. Inspection/Repair d. Reassembly

Materials/Parts

Solvent cleaning compound (RBC)

(item 2, WP 0074 00) Spring, pin, PN 11826068-3 Weapons lubricating oil (as required) Wiping rag, (item 11, WP 0074 00)

Equipment Condition

Bolt assembly disassembled from operating rod (TM 9-1005-313-10).

Was this article helpful?

0 0

Post a comment