Place back plate (23) with threaded end up on a clean surface.

Place sleeve spacer (26) into buffer plug (29). Install braking buffer cone (28) with its base against buffer plug (29).

Place tapered surface of expansion ring (27) against tapered surface on braking buffer cone (28).


Apply light coat of lubricant to all eleven spring washers.

Install eleven spring washers (25) on sleeve spacer (26). Place the concave surface of the first washer against expansion ring (27). Check washer sequence diagram. Place second washer in the opposite direction with its convex surface against the first washer.


Was this article helpful?

0 0

Post a comment