Warning

Point bolt face away from your face and away from other personnel, the spring can fly out and cause injury.

Make sure the first coil on one end of extractor spring assembly (17) is open slightly. Place the open end of the extractor spring assembly (17) in extractor plunger (16). (The open end of the extractor spring assembly should hold the extractor spring assembly in the extractor plunger.) Place extractor spring assembly (7) and extractor plunger (16) in hole in bolt face (19) of bolt assembly (4) (extractor spring assembly end goes in first).

Insert thin edge (10) of combination tool (11) in groove (12) of extractor plunger (16) and thick edge (13) in locking recess (6) in bottom side of bolt assembly (4).

Hold combination tool (11) and push locking lever (7) downward to compress extractor spring assembly (17) and extractor plunger (16).

Insert extractor (15) into bolt assembly (4). Release combination tool (11) until extractor plunger (16) makes contact with extractor (15).

Remove combination tool (11).

Was this article helpful?

0 0

Post a comment