Disassem Blyinspectionrepair Cont

14. Pry Retaining Spring (19) over two Retaining Pins (20). Remove two Retaining Pins (20), Retaining Spring (19) and Cocking Channel Cover (21) from Cover Assembly (5) and separate Retaining Spring (19) from Cocking Channel Cover (21).

1JDU214

15. Visually inspect two Retaining Pins (20) for burrs, and replace if damaged. Visually inspect Cocking Channel Cover (21) for bends or broken Clip (22) and replace if broken or damaged. Visually inspect Retaining Spring (19) for bends or broken ends and replace if damaged.

1JDU214

16. Remove two Screws (23). Remove two Lock Washers (24) and discard. Separate Rear Sight Assembly (25) from Cover Assembly (5).

17. Visually inspect two Screws (23) for burred head and damaged threads. Replace if damaged.

18. Rotate Elevation Knob Assembly (26) so that cross bar of Elevator Assembly (27) is rearward.

19. Push Lock Spring (28) to the front and lift Sight Leaf Assembly (29) up and away from Elevator Assembly (27).

Gun Vise For Sighting

20. Place Rear Sight Assembly (25) in protective jawed vise. Remove Spring Pin (30) and discard.

20. Place Rear Sight Assembly (25) in protective jawed vise. Remove Spring Pin (30) and discard.

Self Locking Knob Assembly

21. Separate Elevation Knob Assembly (26) from Elevator Assembly (27). Separate and discard two Ball Detents (31), two Plungers (32), two Detent Springs (33) and two Detent Springs (34) from Elevation Knob Assembly (26).

Was this article helpful?

0 0

Post a comment