Pin Straight Headless Feed Mechanism

30. Engage Feed Lever (47) on Roller (48). Place on Feed Lever Pivot (49) and drop in place. Be sure Feed Lever (47) is flush with top of Feed Lever Pivot (49).

Mossberg M590 Airsoft

31. Position Retaining Clip (50) with legs pointed rearward and straight leg of clip toward Feed Lever (47) and push into position on Feed Lever Pivot (49).

M249 Gunner Setup

32. Unhook straight leg of Spring (45) by holding hooked leg in place with screwdriver and prying up straight leg with another screwdriver.

Tool Kit Small Arms Repairman Ordnance

To perform remaining reassembly steps, refer to paragraph 2-9.1, Reassembly.

3-15. MAINTENANCE OF RECEIVER ASSEMBLY.

3-15. MAINTENANCE OF RECEIVER ASSEMBLY.

This task covers:

Disassembly/Inspection/Repair/Reassembly

INITIAL SETUP

Tools and Special Tools

Shop Set, Small Arms, Field Maintenance

SC 4933-95-CL-A11 Tool Kit, Small Arms Repairman

USMC TAM No. E2900 Straight Headless Pin MS9486-75 or

Fabricated Pin (fig E-1, app E) Combination Tool 9348248

Personnel Required

MOS 45B Small Arms Repairer MOS 2111 Infantry Weapon Repairer (USMC)

References

TM 9-1005-201-10 TM 08671A-10/1A

Materials/Parts

Wiping Rag (item 3, app D)

Equipment Condition

Weapon field stripped. Cover and Feed Mechanism Assembly removed from Receiver Assembly.

DISASSEMBLY/INSPECTION/REPAIR

1. On lower inside housing of Receiver Assembly (1), depress tang of Gas Cylinder Retaining Spring (2) using a flat-tip screwdriver. At the same time, pull on hooked end of Gas Cylinder Retaining Spring (2) with needle-nose pliers and remove. Discard Gas Cylinder Retaining Spring (2).

NOTE

Gas Cylinder Retaining Spring (2) does not have to be removed from Receiver Assembly (1) for inspection. If it does not retain gas cylinder in Receiver Assembly (1), replace Gas Cylinder Retaining Spring (2).

1095 197 7902

Was this article helpful?

0 0

Post a comment