Torsion Spring is under tension and eye injury can occur if spring snaps out

10. While holding Leg Assemblies (11) firmly together, remove punch. Place Pivot (10) with chamfer toward hooked side of Leg Assemblies (11), aline holes and reinsert punch through Pivot (10), Spring (12) and Leg Assemblies (11).

Torsion Spring Pistols

11. Place Pivot (10) in protective jawed vise and drive NEW large Spring Pin (9) into Pivot (10), Torsion Spring (12) and Leg Assemblies (11) flush, pushing punch out the other side.

12. After positioning slot of NEW small Spring Pin (13) opposite (180°) slot of Large Spring Pin (9), drive in flush.

Torsion Spring Guns
180°
Airsoft Eye Injuries Image

13. Remove Pivot (10) and Leg Assemblies (11) from vise, position Yoke (14) on Pivot (10) with Yoke Lip (15) rearward and Leg Assembly Hooks (16) forward. Drive in NEW, large Spring Pin (17), flush.

14. After positioning slot of NEW small Spring Pin (18) opposite (180°) slot of Large Spring Pin (17), drive in flush.

Torsion Spring Pistols

14. After positioning slot of NEW small Spring Pin (18) opposite (180°) slot of Large Spring Pin (17), drive in flush.

Torsion Spring Pistols
3-14. MAINTENANCE OF COVER AND FEED MECHANISM ASSEMBLY.

This task covers:

Disassembly/Inspection/Repair/Reassembly

INITIAL SETUP

Tools and Special Tools

References

Shop Set, Small Arms, Field Maintenance

TM 9-1005-201-10

SC 4933-95-CL-A11

TM 08671A-10/1A

Tool Kit, Small Arms Repairman

TM 9-4933-273-12&P

USMC TAM No. E2900

Equipment Condition

Personnel Required

Cover and Feed Mechanism Assembly removed

MOS 45B Small Arms Repairer

1 from Machine Gun Receiver Assembly. (Refer to

MOS 2111 Infantry Weapon Repairer

| Para 2-9.1)

DISASSEM BLY/INSPECTION/REPAIR

M60 Receiver Kits

Was this article helpful?

0 0

Post a comment