Materials Required

TUBING

Magazine 34.93 .x. .15:88mm

SPRING STEEL

Magazine . Catch 7/16" .x. .18 . Gauge . Spring. .Steel

Mainspring 20 . Gauge . Spring. .Wire.

FLAT BAR

TOOL STEEL

Trigger Yi.Plate.

ROUND BAR

Note: Measurements are supplied in either Metric or Imperial sizes in accordance with the measurements materials are usually encountered.

GRIP INSERT 35 X 16mm TUBE

GRIP 40 X 20mm TUBE

MAGAZINE

CATCH 7/16" x 20g SPRING STEEL

TRIGGER /" PLATE

MAGAZINE

WELL 40 x 20mm TUBE

SEAR 3/8" TOOL STEEL

TRIGGER GUARD 5/8 x 1/8" FLAT BAR

LOWER RECEIVER

TOD

1 OP

EäBBi

---------------------- 169mm ------------------------------------►

---------------------- 169mm ------------------------------------►

m CUT OUT AND REMOVE SHADED AREAS.

0 HOLE POSITIONS.

The overall length of the template is 169mm.

If the template is not 169mm in length when printed, it can be enlarged as necessary using a photocopier, until the above measurement is achieved.

TRIGGER GROUP RECEIVER

(Hole diameters not to scale)

Sear Hole Lower

7.8mm

SIDE

BOTTOM

Cut Slot 1 - 1.5mm deep to accept base plate spring retainer.

LU

1-

<

_J

Q.

S

LU

1-

cc

<

UJ

Was this article helpful?

0 0

Post a comment