Spacer

Fig. 17

500® AND 590® MODELS 6-SHOT CUT AT 1 5/16" (A) 590 MODELS WITH BAYONET LUG CUT AT 1 7/8" (B) 590 MODELS WITHOUT BAYONET LUG, USE AS IS.

DUAL - COMB® TROPHY STOCK

BEFORE PERFORMING ANY DISASSEMBLY OR ASSEMBLY PROCEDURE:

a. Move the safety button fully rearward to the "ON" (SAFE) position and keep muzzle pointed in a safe direction.

b. Open the action, visually and physically check chamber, elevator and magazine tube to be certain the firearm is unloaded.

To Change Removable Combs:

1) Using a 3/16 inch Allen head wrench (supplied) unscrew and remove the comb retaining screw found at the top center of the removable comb.

2) Place the desired comb into position. Insert the comb retaining screw and snug-tighten. Do not overtighten as this will damage the internal assembly components.

ACCU, ACCU-STEEL, ACCU-MAG CHOKE TUBES

BEFORE REMOVING OR INSTALLING ANY CHOKE TUBE:

a. Move the safety button fully rearward to the "ON" (SAFE) position and keep muzzle pointed in a safe direction.

b. Open the action, visually and physically check chamber, elevator and magazine tube to be certain the firearm is unloaded.

Do not use bent or deformed tubes as these may result in tube or barrel damage upon firing. Inspect tubes periodically as to insure they are properly installed and in good condiiton. Pay special attention to the threaded end of the tube to be certain it is not deformed or dented.

Never fire the shotgun without a choke tube properly installed. Failure to do so will damage the precision threads on the inside of the barrel.

CARE & CLEANING: The precision threads on your choke tube should be kept clean and lightly oiled at all times.

During cleaning of the barrel, be certain a choke tube is properly installed. This will avoid residue build-up on threads.

Extra-Full choke tubes are not recommended for use with buckshot or slugs.

The "Improved Cylinder' choke tube will usually produce the best accuracy with most slugs.

= ACCU CHOKE TUBES =

AACCU-CHOKE TUBES - are designed for Best Lead Shot Patterns. STEEL SHOT can be fired through Accu-choke tubes however, better steel shot patterns may be obtained by using ACCU-STEEL choke tubes.

To remove choke tube, loosen it with the choke wrench provided, turning counterclockwise. When loose, remove completely with fingers, put choke on a clean dry surface.

To install choke tube, first screw the tube clockwise into barrel by hand and then tighten the tube until snug with a choke wrench. Do not use excessive force when installing. Tube tightness should be checked periodically. Accu tubes fit competely inside the muzzle of the barrel when fully installed.

Was this article helpful?

0 0

Post a comment