Warning If there is a charge in the barrel do not attempt to remove it by shooting it out if you are unsure what the

See page 10. 4. Remove the nipple. See page 12. 5. Remove the breech plug. See page 11. 6. Insert the bore cleaning tube into the receiver and against the breech plug threads. Do not thread this tube into the barrel. 7. Attach a bore mop to the ramrod with the extension and handle assembled and insert it through the bore cleaning tube and into the barrel. 8. Place the muzzle in clean, hot water and pull the bore mop back through the barrel into the bore cleaning...

In the case of a misfire or hangfire proceed as follows

Keep the rifle pointed in a safe direction for at least one full minute with the bolt in the closed position. BE PREPARED FOR THE RIFLE TO FIRE AT ANY INSTANT. 2. After no less than one minute open the bolt assembly, keeping the rifle pointed in a safe direction. 3. Put the safety mechanism in the 'S' position. See page 9. 4. Remove the percussion cap from the nipple and use a nipple pick to ensure that the flash hole through the nipple is clear. 5. Place a new percussion cap on the nipple....

To Assemble The Bolt Assembly

Slide the firing pin assembly into the rear of the bolt assembly. 2. Tighten the firing pin assembly by hand only. 3. Pull the coin from the slot in the firing pin head. 4. Align the firing pin head with the small notch in the rear of the bolt assembly. The bolt is now cocked. See Picture 23. 5. Assemble the bolt assembly in the receiver. See instructions on page 9.

Been Deactivated

Remove the action from the water and pour the water from the bore. 8. Remove the breech plug and proceed to step 9. If the breech plug cannot be removed, attach a screw type bullet puller to the ramrod. Keep the ramrod directed away from your face and body while attempting to remove the projectile. Insert the ramrod with the attached bullet puller into the muzzle and twist the bullet puller into the bullet.

Telescopic Sights

The top of the receiver has holes for the installation of telescopic sights. The same Model 700 two-piece scope mounts that fit the centerfire rifles will fit on this muzzleloader. Model 700 Short Action one-piece scope mounts will also fit. NOTE The use of telescopic sights are illegal in some areas during the big-game muzzleloading season. Be sure to check the regulations in the area you will be hunting before installing the scope. This Remington Model 700 ML is shipped with an optional...

Dont Keep This To Yourself

Ramrod Support 700ml

Now that you're a gun owner you have the obligation to help ensure that shooting sports are safe for everyone -participants and bystanders alike. You can do that by practicing these principles of firearm safety and passing them on to others - especially new shooters. Set an example for beginners. Be a guide to their safe entry into the exciting world of shooting sports. Invest your time and patience for the love of the sport and for its future. After all, it's your love of the sport that led...