External Locking Device Installation Instructions

A WARNING - USE OF LOCKING DEVICES

• Always keep your firearm pointed in a safe direction, including when you are installing or removing your locking device.

• Always verify that your firearm is completely unloaded before installing your locking device.

• Do not install locking devices in the trigger guard; always keep your fingers and locking device outside the trigger guard during device installation and removal.

• Store firearms, ammunition and keys separately and securely, away from children and careless adults; do not store your firearm with the keys in the locking device.

• Do not attempt to work the action of your firearm with the locking device in place; this may damage your firearm.

• While locking devices are an important aid to security measures, they are not a substitute for safe firearm handling and proper storage. Remember that any mechanical device can be bypassed with enough time, knowledge, determination and equipment.

LOCKING DEVICES MUST BE USED SAFELY AND RESPONSIBLY

Use the Correct Lock: While the basic locking device is substantially similar for all Ruger® firearms, due to the different shapes of the many Ruger® firearms, some firearms utilize different locking devices. 50th ANNIVERSARY NEW MODEL BLACKHAWK® revolvers utilize a 2 1/2" lock. It is very important to use the correct locking device!

To Install the Factory-Supplied External Locking Device:

1. Keep the muzzle pointed in a safe direction and your fingers outside the trigger guard at all times!

2. Be sure the firearm and its cylinder are completely unloaded and contain no cartridges or cartridge casings!

3. Completely remove the cylinder by opening the loading gate, pressing the basepin latch, pulling the basepin fully forward, and rotating the cylinder out of the frame.

4. Loop the shackle through the cylinder window in the frame. Next slip the cylinder onto the shackle of the lock as shown in Figure 1.

5. Close the lock by pressing the shackle into the body of the lock (the part that receives the key) as tightly together as possible. The lock has bumpers and the shackle is coated with a non-marring material that will not harm the metal finish of your firearm; be careful not to dent the frame or grip panels of the revolver.

6. Once the lock is securely closed, remove the key and pull firmly on the lock to test the connection and be sure it is locked. Do not leave or store your firearm with the key in the lock! Store your locked, unloaded firearm and the key in secure, separate locations, away from ammunition, children, or unauthorized adults.

Ruger Blackhawk Pellet Gun

Correct Installation of Lock For Ruger® New Model Blackhawk Revolvers

Was this article helpful?

0 0

Post a comment