Firing Warning

When firing the rifle, be sure that other shooters and bystanders are a safe distance to the rear. Empty cartridge cases arc cjcctcd from the rifle with some velocity and could cause injury to any person in their path. AH shooters should wear shooting glasses when firing any firearm. Hearing protection must also be worn because exposure to shooting noise can damage hearing.

The table below shows the correct cartridges to be used in the short action and long action models:

SHORT ACTION

LONG ACTION

.220 Swift

.25-06 Remington

.22-250 Remington

.257 Roberts

.223 Remington

.270 Wincltestei

.243 Winchester

280 Remingion

6 mm Remington

7 x 57 Mauser

.250 Savage

7 mm Remington Magnum :

.284 Remington

.30-06 Springfield

7 mm 08 Remington

300 Winchester M.igmim

.308 Winchester

.338 Winchester Magnum

.350 Remingion Magnum

.35 Wlielcn

.358 Winchester

.458 Winchester Magnum

TRIGGER ADJUSTMENT

The minimum weight of pull is established by the trigger return spring, part L>-49. This spring should not be modified. The weight of pull can be increased beyond this minimum by tightening the adjusunent screw for weight of pulL D-43. Do not attempt to decrease the weight of pull below this pre set minimum, or an unexpected discharge may result.

All other trigger adjustment screws are pre set at the factory and permanently secured. Do not attempt to adjust these. Any change in this original adjustment can in rare circumstances, cithercause the rifle to lire unexpectedly (with the safety FT) or not permit the rifle u> fire at all. See exploded parts diagram page 14.

WARNING: BE CERTAIN RIFLE lii NOT LOADED BEFORE WORKING ON IT.

TRIGGER ADJUSTMENT

The minimum weight of pull is established by the trigger return spring, part L>-49. This spring should not be modified. The weight of pull can be increased beyond this minimum by tightening the adjusunent screw for weight of pulL D-43. Do not attempt to decrease the weight of pull below this pre set minimum, or an unexpected discharge may result.

All other trigger adjustment screws are pre set at the factory and permanently secured. Do not attempt to adjust these. Any change in this original adjustment can in rare circumstances, cithercause the rifle to lire unexpectedly (with the safety FT) or not permit the rifle u> fire at all. See exploded parts diagram page 14.

WARNING: BE CERTAIN RIFLE lii NOT LOADED BEFORE WORKING ON IT.

Was this article helpful?

0 0

Post a comment