Procedure

1. Slide the front stock 701 onto the gun and press the sides of the front stock into the sides of the magazine tube.

2. Hand-tighten the front stock screw clockwise with the short end of the special Torx spanner supplied. If you are using a torque wrench, the tightening torque should be 3 Nm.

3. Fit the sling attachment (see section 8.4).

gdSP

Assembly

W' 1

I Mounting telescopic isi-Mount

Fig. 23

The housing of the SAUER 303 is already prepared for the mounting of the new SAUER telescopic sight "isi-Mount" (individual, selective, integrated) (see Fig. 24).

Fig. 23

Was this article helpful?

0 0

Post a comment