Sat Comm Procedure

1. FUCTION SWITCH TO SAT,

2. DISPLAY SWITCH ON BRIGHT.

3. UP-LINK FREQ MODE SWITCH TO X2.

4. SAT OFFSET SWITCH TO A,B,C, OR D.( FOUR SETS OF FREQS CAN BE PRESET FOR QUICK ACCESS).

NODE SWITCH TO XI. ( DOWN-LINK FREQ ) 6. CALL SWITCH TO SEND.

8. WHILE HOLDING CALL SWITCH IN SEND, ADJUST KHz AND KHz, UP OR DOWN TD DESIRED FREQUENCY

9., RELEASE CALL SWITCH, < AFTER DESIRED FREQS. ARE ENTERED.) THIS WILL LOAD FREQS AND WILL AUTOKATICLY RETURN TO RCV POSTION.

11. REPEAT STEPS 6 THROUGH 9 .

12. RETURN MODE SWITCH TO X2. ( TO TRANSMIT )

1. PSC-3 VOLUNE SWITCH ON FULL,

2. PSC-3 SQUELCH SWITCH TURNED, ON.

3. SELECT PROPER DAY CHANNEL 1 - 6 ON THE KY-57.

5. XKT POWER SWITCH ON TH PSC-3, ADJUSTED TO 3/4 POWER. ( JUST TOUCHING THE GREEN LINE )

6. SET SPKR/MODE SWITCH, ON KY-57 TO, PT. < PLAIN TEXT. )

7. POINT DMC-120 SATELITE ANTENNA IN PROPER COMPASS DIRECTION AND ELEVATION.

8. KEY HANDSET AND RELEASE.( SPLASH SHOULD BE HEARD ), ONCE A SPLASH IS OBTAINED.

9. SET THE SPKR/MODE SWITCH TO CT ON THE KY-57.

Was this article helpful?

0 0

Post a comment