Removing The Handguard

CAUTION

THE HANDGUARD RETAINING PIN IS A CAPTUHED PIN. DO NOT ATTEMPT TO REMOVE IT COMPLETELY DURING DISASSEMBLY.

i. REMOVING THE BUTTSTOCK AND SHOULDER ASSEMBLY.

To remove the buttstock and shoulder assembly, use a cartridge or the spring guide rod to push the lowermost retaining pin on the rear of the receiver. Remove the buttstock and shoulder assembly by pulling it rearward while supporting the trigger mechanism.

M249 Saw Trigger Assembly

CAUTION

THE UPPER AND LOWER RETAINING PINS IN THE REAR OF THE RECEIVER ARE CAPTURED PINS. DO NOT ATTEMPTTO REMOVE THEM COMPLETELY DURING DISASSEMBLY.

To separate the trigger mechanism from the receiver, pull down on it.

j. REMOVING THE GAS CYLINDER GROUP. To remove the gas cyl inder from the receiver, grasp the gas cylinder forward of the bipod legs, turn it to the left or right to release the locking spring, and then pull forward on it.

REMOVING THE GAS CYLINDER GROUP

k. REMOVING THE BIPOD GROUP. Once the gas cylinder is removed, the bipod group can also be removed from the receiver.

Was this article helpful?

0 0

Responses

  • jana
    How to remove the handguard on m249 saw?
    1 year ago
  • DOMENICO
    What is the first step in removing the handguard m249?
    7 months ago
  • john
    What is the first step in removing the handguard m249saw?
    6 months ago
  • Yolanda
    How to remove the trigger mechanism m249?
    3 months ago
  • p
    What is the first step in removing the handgaurd m249?
    22 days ago

Post a comment