Changing The Lamp

1. Remove the Head from the Body by rotating the Body counterclockwise (as viewed from the tail) until it separates from the Head.

2. Access to the Lamp Assemblies requires removing the Reflector from the Head. Using a 5/32" Allen wrench, remove the Allen Screw positioned in the center of the spring located inside of the base of the Head to release the Reflector from the Head.

3. Carefully separate the Reflector from the Head and replace the inoperative Lamp. Avoid touching Lamp envelope to prevent degrading the surface.

4. Reinstall the Reflector on to the Head and secure with the Allen Screw. Reinstall the Head on to the Body.

Constant Light

Turn Head (CCW) for Working Beam, add 2/3 turn for High-Power Beam

Two-Step PUSH BUTTON

Was this article helpful?

+1 0

Post a comment