Photo A

Projectile inserted in the

Quick Load Accurizor (QLA) Muzzle, perfectly aligned.

Choking up on your ramrod, or with a short starter, drive the projectile into the bore. There will be a minimal amount of resistance to overcome initially. (See Photo B)

Once the projectile is in the bore, using short strokes with your ramrod, push the projectile the remainder of the way down the bore, until it makes contact with the Pyrodex pellets. Seat firmly, but do not pound on it, as this will likely crush the Pyrodex pellets, which will affect accuracy and the reliability of ignition. It could also deform the bullet. (See Photo C)

Was this article helpful?

0 0

Post a comment