Trigger Adjustment For The System

install Niesle pm«ibr

ESc-larc Dry F ring install Niesle pm«ibr

ESc-larc Dry F ring

Thompson Center Hammer Sear Trigger

Any adjustments are to be made to Screws "A" and "B". A .050" hex wrench and a 1/4" open end wrench are required to perform adjustments.

The trigger of the System 1™ is factory set for optimal weight of pull, sear engagement and over-travel. If further adjustment is required, the System 1™ is equipped with two trigger adjustment screws that can be adjusted by the shooter. If the shooter is not able to make the appropriate adjustments the adjustments should be made by a qualified gunsmith.

In the diagram above, Screw "A" is used to adjust the sear engagement. Sear engagement adjustment refers to the distance the trigger has to be moved rearward to release the sear which in turn allows the striker to fall from the "Cocked" position to the "Fired" position.

Screw "B" is used to adjust over-travel. Over-travel is described as the amount of rearward trigger movement after the trigger releases the striker.

Was this article helpful?

0 0

Responses

  • faruz
    How to fix thomson center muzzleloader trigger?
    5 years ago
  • semrawit
    How to repair muzzleloader trigger?
    4 years ago

Post a comment