Magazine Disassembly

• Refer to Figure 15 for magazine disassembly and reassembly.

• Using a drift punch, depress the floorplate catch(4) through the hole in the magazine floorplate (5).

• Slide the magazine floorplate (5) off of the magazine tube (1) while holding the floorplate catch (4) in the magazine tube.(1)

• Remove the floorplate catch (4) and magazine spring (3) out through the bottom of the magazine tube (1).

• Turn the magazine tube (1) right side up and remove the magazine follower (2) through the bottom of the magazine tube (1).

• Install magazine follower (2) in the bottom of the magazine tube (1) with the notched edges of the magazine follower (2) toward the round side of the magazine tube (1).

• Install the magazine spring (3) and floorplate catch (4) in the magazine tube (1).

• While holding the floorplate catch (4) in the magazine tube (1), slide the magazine floorplate (5) onto the magazine tube (1) so that the round projection of the floorplate catch (4) engages the magazine floorplate (5).

Was this article helpful?

0 0

Post a comment