Assembly

Your new Select shotgun will come from the factory partially disassembled in a special box. Remove the barrel assembly (with forearm attached) and receiver/stock section from the carton. Wipe them clean and lightly oil component parts as explained under "Initial Cleaning/Oiling" (Page 9).

release latch and angle the forearm down and off.

Pull downward on the forearm's release latch and angle the forearm down and off.

Pull downward on the forearm's

It is important to carefully follow the assembly instructions below to assure the proper assembly of your shotgun.

Important: These instructions assume you are assembling your Select from its disassembled form, exactly as it comes from the factory. The forearm should come attached to the barrels. The buttstock/receiver section and the barrel/forearm section should be two separate components.

Was this article helpful?

0 0

Post a comment