Inyector Plus Choke Tube System

The Select is fitted with one of the most popular and universally accepted choke tube systems on the market: Invector-Plus™. Your Select shotgun is specially designed for this system only. Your choke tubes may be marked "Win-Plus." There is no difference This means:

• It is threaded to accept Invector-Plus choke tubes only.

The Invector-Plus system allows you to configure your Select for the patterns and/or choke constrictions your hunting or target situation demands. The system gives you the most highly engineered choke tapers — designed to produce the best possible patterns for target and field situations. Plus, it is extremely easy to switch choke constrictions to match your shooting conditions. Invector-Plus tubes are compatible with steel and lead shot. Most Invector-Plus choke tubes fit flush with the muzzle when installed. A special choke tube wrench is provided to remove and tighten the choke tubes.

Invector-Plus (Win-Plus) choke tubes are NOT interchangeable with any other choke tubes on the market including chokes listed as "Standard Invector™" or Winchester's current line of "WinChokef" choke tubes.

USE ONLY CHOKE TUBES MARKED INVECTOR-PLUS IN YOUR SELECT. USE ONLY THE APPROPRIATE GAUGE OF INVECTOR-PLUS CHOKE TUBES AS MARKED ON YOUR SHOTGUN.

Failure to follow these warnings may damage your firearm and cause injury to yourself and others. A special "Plus" choke tube wrench is provided to remove and tighten Invector-Plus choke tubes.

DO NOT FIRE THIS SHOTGUN WITHOUT HA VING AN INVECTOR-PLUS CHOKE TUBE INSTALLED. PERMANENT DAMAGE MAY RESULT TO THE THREADS.

CAUTION: WHENEVER HANDLING ANY SHOTGUN FOR THE PURPOSE OF REMOVING OR INSTALLING A CHOKING DEVICE, MAKE ABSOLUTELY CERTAIN THE FIREARM IS FULLY UNLOADED, AND THE ACTION IS OPEN! NEVER ATTEMPT TO REMOVE OR INSTALL A SHOTGUN CHOKING DEVICE IN A LOADED FIREARM!

UNLOAD YOUR SELECT SHOTGUN FULLY. INSPECT THE CHAMBERS TO MAKE SURE THEY DO NOT CONTAIN ANY SHELLS.

1. Open the action and place the safety in the "on safe" position.

1 Notch: Full

3 Notches: Modified

5 Notches: Skeet

1 Notch: Full

3 Notches: Modified

5 Notches: Skeet

No Notches: Cylinder

2 Notches: Improved Modified

4 Notches: Improved Cylinder

No Notches: Cylinder

Tube Notch Codes (Lead shot designations). Small notches indicate the choke code. Large notches are for the choke tube wrench.

2. Use the Invector-Plus wrench to loosen the tube, turning it counterclockwise. Finger twist the tube the rest of the way out of the barrel.

Was this article helpful?

0 0

Post a comment