Do Not Alter Or Attempt To Disassemble Any Part Of The Trigger Group Or Remove Or Disassemble The Bol T Mechanism

If any service of the trigger group or bolt becomes necessary, send your rifle to the Winchester Rifles and Shotguns Service Center in Arnold, Missouri (page 23).

Push the two trigger group pins

Push the two trigger group pins

1. BE CERTAIN THE RIFLE IS COMPLETEL Y UNLOADED AND THE SAFETY IS IN THE "ON SAFE" POSITION.

Again, to unload your rifle, remove the magazine and eject any live cartridge in the chamber by pulling the operating handle to the rear.

2. Release the bolt to its forward position.

3. Push in the two trigger group pins from either the right or left side of the receiver. Use a drive punch or similar object, using care not to scratch the gun's receiver (Figure 10). Push the trigger group pins clear through the receiver.

4. Grasp the trigger guard and pull the trigger group out of the receiver (Figure 11).

Vfet i

» Lift the trigger group from W the receiver.

—~ * .

Was this article helpful?

0 0

Post a comment